هوم › / نيسان برجمة التوجيهية / المهنية الصانع من المحور الأمامي برجمة التوجيهية

المهنية الصانع من المحور الأمامي برجمة التوجيهية

رقم LZSK: نموذج lz-ns237

الألوان: بلاك ›

قدرة العرض: عشرة آلاف قطعة في الشهر

نوع: برجمة التوجيهية

طلب اقتباس

تفصيل

موانئ:شنغهاي أو نينغبو

الحد الأدنى للطلب:مجموعة

مادة:صب الصلب

تغليف:كارتون صينية

وصف المنتج
The steering drive shaft is widely used in automobiles. In cars with front-engine rear wheels or all-wheel drive, due to the deformation of the elastic suspension, the relative positions of the transmission or transfer output shaft and the drive axle input shaft often change, so the cross-shaft steering drive shaft is generally used. In the steering drive axle, the angle between the inner and outer half shafts changes with the driving needs, and the constant speed steering drive shaft is often used at this time. When the rear drive axle is an independent suspension, the steering drive shaft must also be used. Variable speed steering knuckle refers to a steering knuckle with a variable instantaneous angular velocity ratio between the output shaft and the input shaft when the angle between the two shafts connected by the steering knuckle is greater than zero, but the average angular velocity ratio is 1. Quasi-constant speed steering knuckle refers to a steering knuckle that transmits motion at an instantaneous angular velocity ratio equal to 1 when working at a design angle, and the instantaneous angular velocity ratio is approximately equal to 1 when working at other angles. The knuckle that the output shaft and the input shaft transmit motion at an instantaneous angular velocity ratio equal to 1 is called a constant velocity knuckle.