وصف المنتج
The steering knuckle is the hinge for turning the wheels, and is generally fork-shaped. The upper and lower forks have two coaxial holes for installing the kingpin, and the steering knuckle journal is used to install the wheel. The two lugs of the pin hole on the steering knuckle are connected with the fist-shaped parts at both ends of the front axle through the king pin, so that the front wheel can deflect a certain angle around the king pin to turn the car. In order to reduce wear, a bronze bushing is pressed into the steering knuckle pin hole, and the bushing is lubricated by the grease nipple installed on the new steering knuckle. The steering drive shaft is widely used in automobiles. In cars with front-engine rear wheels or all-wheel drive, due to the deformation of the elastic suspension, the relative positions of the transmission or transfer output shaft and the drive axle input shaft often change, so the cross-shaft steering drive shaft is generally used. In the steering drive axle, the angle between the inner and outer half shafts changes with the driving needs, and the constant speed steering drive shaft is often used at this time. When the rear drive axle is an independent suspension, the steering drive shaft must also be used.
الشركة المصنعة للمعدات الأصلية
lzsk-ty328 lz-ty328
السياراتمعدات النمذجةبويك انكور
تفاصيل المنتج
برجمة التوجيهية
ضمان لمدة ثلاث سنوات ، ثلاث سنوات
تشجيانغ ، الصين
الأبعاد القياسية تصنيع المعدات الأصلية
بويك أنكور
منتج من جنرال موتورز
علبة كرتون
شهادة ISO16949
ليان رويان
داخل كيس من البلاستيك ، مربع الداخلية ، كارتون ، صينية
فترة متقدمة